![]() Good luck!Įdit: nevermind, you've got a support contract with Dell still! They'll take good care of you. Again, not something i've tried on a very modern equallogic, so it might not work at all, and not something i've tried on a working production system. Dedicated 10/100 management port per controller. Dual controllers designed for built-in redundancy. You may need to remove the passive controller while resetting the active, then switch and do the other one. Master the most demanding enterprise applications with Dell EqualLogic PS6100S Internet SCSI (iSCSI) arrays, featuring high-performance, low-latency solid state drives. Once it comes back up, you should be able to login with grpadmin/grpadmin. ![]() Do this, then you'll be at a CFE prompt.Īt this prompt, to reset the password to default, type the following ![]() You basically reboot the controller you want to reset, and immediately after it bounces, it will prompt you to pressĬtrl+p to enter setup mode. ![]() Disclaimer: I've never tried this on a production system where I cared about the data, but it should be fine. There was a way to do this, not sure if it's been knocked out by newer firmware or only worked in older models. Unfortunately, it has had the grpadmin password changed (expected as I think you have to do that as soon as you log in for the first time).Īny idea on how you get a password reset achieved on one of these things without knocking the entire config out?
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |